FIAT Qubo User Manual

Page 20

SAFETY

TING

AND DRIVING

ARNING

LIGHTS AND MESSAGES

IN AN

EMERGENCY

MAINTENANCE

AND CARE

TECHNICAL

SPECIFICA

TIONS

INDEX

DASHBOARD AND CONTROLS

Setting the speed limit (SPEEd)

This function is used to set the vehicle
speed limit (km/h or mph); when this lim-
it is exceeded the driver is immediately
alerted (see section “Warning lights and
messages”).

To set the speed limit, proceed as follows:

– briefly press button MENU ESC, the
message (SPEEd) and the previously set
unit (km/h) or (mph) will appear on the
display;

– press button + or – to select speed lim-
it activation (On) or deactivation (OFF);

– if the function has been activated (On),
press buttons + or – to select the re-
quired speed limit and then press MENU
ESC to confirm;

Note The speed may be set in the range
from 30 to 200 km/h, or from 20 to 125
mph according to the previously chosen
unit (see “Setting the distance unit”) de-
scribed below. The setting will in-
crease/decrease by five units each time
button +/– is pressed. Hold button +/–
pressed to increase/decrease the setting
rapidly. When close to the desired value,
press the button as many times as re-
quired to complete the regulation.

– Briefly press button MENU ESC to go
back to the menu screen or press the but-
ton for long to go back to the standard
screen without storing settings.

To cancel the setting, proceed as follows:

– briefly press button MENU ESC: (On)
will flash on the display;

– press button –: (Off) will flash on the dis-
play;

– briefly press button MENU ESC to go
back to the menu screen or press the but-
ton for long to go back to the standard
screen without storing settings.

Setting the clock (Hour)

With this function it is possible to set the
clock.

To set the required unit proceed as fol-
lows:

– briefly press button MENU ESC,
“hours” will flash on the display;

– press button + or – for setting;

– briefly press button MENU ESC: the
“minutes” start flashing on the display;

– press the button + or – to set the de-
sired value;

– briefly press button MENU ESC to go
back to the menu screen or press the but-
ton for long to go back to the standard
screen without storing settings.

Adjusting the buzzer volume
(bUZZ)

This function is used to adjust the volume
of the buzzer triggering in the event of fail-
ure/warning indications and when MENU
ESC, + and – buttons are pressed.

To adjust the desired volume proceed as
follows:

– briefly press button MENU ESC, the
display will show the wording (bUZZ);

– press button + or – to select the re-
quired volume (volume can be adjusted ac-
cording to 8 levels).

– briefly press button MENU ESC to go
back to the menu screen or press the but-
ton for long to go back to the standard
screen without storing settings.

001-035 Fiorino GB 1ed 21-10-2008 14:57 Pagina 19