FIAT Qubo User Manual

Page 126

125

SAFETY

MAINTENANCE

AND CARE

TECHNICAL

SPECIFICA

TIONS

INDEX

DASHBOARD AND CONTROLS

TING

AND DRIVING

ARNING

LIGHTS AND MESSAGES

IN AN

EMERGENCY

❒ fit the standard wheel by inserting the

first stud B-fig. 10 for two threads in
the hole closest to the inflation valve A;

❒ fit the wheel cap, making the symbol

(on the back of the cap) coincide with
the inflation valve and fit the other three
bolts;

❒ fasten bolts using the wrench provided;
❒ retract the jack until the vehicle rests

on the ground and pull the jack out.

❒ use the wrench provided to tighten the

bolts completely in a criss-cross fashion
following the numerical sequence shown
in fig. 11.

After tyre replacement
❒ Fasten the toothed support on the

drilled wheel by means of the 2 screws
(insert the support from outside the
wheel). Rehook the metallic retaining
cable in the specific seat and reinsert
the protection cap A-fig. 12.

❒ Check replaced wheel positioning un-

der the floor (the lifting system is sup-
plied with a clutch to limit the end of
the stroke). Incorrect positioning may
jeopardise safety.

❒ Lift again the wheel tightening again the

lock bolt A-fig. 4.

❒ Put the jack and tools back in the tool

box.

❒ Position the tool box in the boot.
❒ Secure the box using the retention

straps.

fig. 10

F0T0282m

fig. 11

F0T0293m

fig. 12

F0T0170m

119-150 Fiorino GB 1ed 21-10-2008 15:05 Pagina 125