FIAT Qubo User Manual

Page 169

168

SAFETY

TECHNICAL

SPECIFICA

TIONS

INDEX

DASHBOARD AND CONTROLS

TING

AND DRIVING

ARNING

LIGHTS AND MESSAGES

IN AN

EMERGENCY

MAINTENANCE

AND CARE

Replacing the rear window wiper
blade (where provided)

Proceed as follows:
❒ lift the cover A-fig. 11 and disassemble

the arm from the vehicle by turning the
nut B securing it to the rotation pin;

❒ fit the new arm, positioning it correct-

ly, and fully tighten the nut;

❒ lower the cover.

SPRAY NOZZLES

If the jet of fluid is inadequate, firstly check
that there is fluid in the vessel of the wind-
screen/rear window wiper (where pro-
vided) (see “Checking fluid levels” in this
section).

Then, make sure that the outlet holes are
not clogged. Unclog them using a needle,
if required.

Front window (window washer)

Front window washer jets are fixed. The
nozzle holders are positioned under the
bonnet (see fig. 12).

Rear window
(rear window washer)

Rear window washer jets are fixed. The
nozzle holder is on the rear window (see
fig. 13).

fig. 11

F0T0213m

fig. 12

F0T0090m

fig. 13

F0T0214m

151-172 Fiorino GB 1ed 21-10-2008 15:02 Pagina 168