FIAT Qubo User Manual

Page 129

128

SAFETY

MAINTENANCE

AND CARE

TECHNICAL

SPECIFICA

TIONS

INDEX

DASHBOARD AND CONTROLS

TING

AND DRIVING

ARNING

LIGHTS AND MESSAGES

IN AN

EMERGENCY

❒ make sure that switch E-fig. 17 on the

compressor is in position 0 (off), start
the engine, plug into the socket D-fig.
16 and operate the compressor turn-
ing switch E-fig. 17 to position I (on).
Inflate the tyre to the pressure speci-
fied in the “Inflation pressure” para-
graph in the “Technical Specifications”
section. For a more accurate reading,
check the pressure on gauge F-fig. 17
with the compressor off:

❒ if after 5 minutes it is still not possible

to reach at least 1.5 bar, disengage the
compressor from the valve and current
outlet, then move the vehicle forth for
approx. ten metres in order to distrib-
ute the sealing fluid inside the tyre even-
ly. Then, repeat the inflation operation;

❒ if after this operation it is still not pos-

sible to reach at least 1.8 bar after 5
minutes, do not start driving since the
tyre is excessively damaged and the fast
tyre repair kit cannot guarantee suit-
able sealing. Contact the Fiat Dealer-
ship;

❒ if the tyre is inflated at the pressure val-

ue specified in paragraph “Cold inflation
pressures”, “Technical Specifications”
section, start driving immediately;

❒ After driving for about 10 minutes stop

and check the tyre pressure again; pull
up the handbrake.

fig. 16

F0T0133m

fig. 17

F0T0131m

fig. 18

F0T0191m

Affix the adhesive label in an
easy-to-see position for the

driver as a reminder that the tyre has
been treated with the fast repair kit.
Drive carefully, particularly on bends.
Do not exceed 80 km/h. Do not ac-
celerate and brake suddenly.

WARNING

119-150 Fiorino GB 1ed 21-10-2008 15:05 Pagina 128