FIAT Panda - Manual (Page 157)

DIRECTION INDICATORS
Front
To change the bulb, proceed as follows:
❒ remove cover B fig. 115;
❒ turn the bulb holder anticlockwise, extract the
bulb and replace it;
❒ refit the new bulb on the connector making sure
that it is locked correctly, then reinsert the
connector in its housing rotating it clockwise;
Side
To change the bulb, proceed as follows:
❒ adjust the lens A fig. 117 to compress in the
internal catch B, then pull the unit outwards;
❒ turn the bulb holder C anticlockwise, extract the
bulb and replace it;
❒ refit the bulb holder C in the lens and turn it
clockwise;
❒ refit the unit making sure that the internal catch B
clips into position.
FOG LIGHTS
(for versions/markets, where provided)
Replace the bulb as follows:
❒ steer the wheel completely;
❒ adjust the screws A fig. 118 and remove the flap B;
❒ adjust the catch C fig. 119 and disconnect the
electrical connector D;
❒ turn and remove the bulb holder E;
❒ release and replace the bulb;
❒ refit the new lamp and carry out the procedure
described previously in reverse.
fig. 117 F0W0209
fig. 118 F0W0197
153
GETTINGTO KNOW
YOURCAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX