MITSUBISHI ELECTRIC LDT462V - Manual (Page 59)

English-55
English
PIP POP SIDE BY SIDE
ASPECT
SIDE BY SIDE
FULL
OFF
PIP, POP function
The following table shows the combinations of signal inputs with which the “PIP” and “POP” modes function. However, these modes
do not function when the screen size is “CUSTOM” or “REAL”.
Sub screen
HDMI DVI-D D-SUB OPTION* YPbPr S-VIDEO VIDEO
Main
scre
e
n
HDMI Ч Ч Ч Ч Ч  
DVI-D Ч Ч Ч Ч Ч  
D-SUB Ч Ч Ч Ч Ч  
OPTION* Ч Ч Ч Ч Ч  
YPbPr Ч Ч Ч Ч Ч  
S-VIDEO      Ч Ч
VIDEO      Ч Ч
 : Supported × : Not supported
* OPTION can be used when an extension module is mounted on the option slot.
By pressing the PIP ON/OFF button on the wireless remote control, you can change the PIP, POP, and SIDE BY SIDE modes in the
order shown below.
Alternatively, you can change the modes using the PIP MODE setting of PIP in the OSD main menu. See page 47.
The resolutions in the PIP and SIDE BY SIDE FULL modes are as follows:
PIP SIZE < SMALL > : 450 pixels X 338 pixels
< MIDDLE > : 675 pixels X 450 pixels
< LARGE > : 900 pixels X 675 pixels
SIDE BY SIDE FULL : 960 pixels X 1080 pixels
NOTE:
When the PIP or SIDE BY SIDE FULL mode has been selected, images in the sub picture always fi t the size of each mode shown
above irrespective of the aspect ratio of the input image.
Other functions (continued)