U-12 remote control (continued), English – MITSUBISHI ELECTRIC LDT462V User Manual
Page 43
English-39
English
4) Operation
commands
The operation commands confi gure the basic operation settings of this LCD monitor. The commands may not work during signal
switchover.
The operation commands have no data codes.
Operation
ASCII
HEX
POWER ON
!
21h
POWER OFF
"
22h
FORCE POWER OFF WITH OPS*
""
22h 22h
INPUT HDMI
_r1
5Fh 72h 31h
INPUT DVI-D
_r2
5Fh 72h 32h
INPUT D-SUB
_r3
5Fh 72h 33h
INPUT OPTION**
_r5
5Fh 72h 35h
INPUT VIDEO
_v1
5Fh 76h 31h
INPUT YPbPr
_v2
5Fh 76h 32h
INPUT S-VIDEO
_v3
5Fh 76h 33h
VOLUME UP
r06
72h 30h 36h
VOLUME DOWN
r07
72h 30h 37h
AUTO SETUP
r09
72h 30h 39h
AUDIO MUTE
ra6
72h 61h 36h
*
Used when the OPS-compliant computer makes no response.
** OPTION can be used when an extension module is mounted on the option slot.
• When you send the POWER ON or POWER OFF command, send the next command at intervals of at least 7 seconds.
• It is recommended that after sending a command for video input selection, wait for at least 5 seconds to send the next
command. Otherwise, the monitor may not reply within 600 ms.
• In the power-off mode, only the POWER ON operation command and the power status acquisition commands described in
the next paragraph work.
• In the sleep mode, only the POWER ON and POWER OFF operation commands and the power status acquisition commands
described in the next paragraph work.
• When no OPS-compliant module is mounted, the operation command for FORCE POWER OFF WITH OPS is unavailable.
• When an OPS-compliant module is mounted, all the input connectors don’t enter the sleep mode.
• Use the operation command for FORCE POWER OFF WITH OPS when the OPS-compliant module doesn’t respond.
U-12
Remote control (continued)
Carry out as necessary