MITSUBISHI ELECTRIC LDT462V - Manual (Page 24)

English-20
HDMI cable
YPbPr IN AUDIO IN2
(RCA)
HDMI IN
To D connector output
To video output
To HDMI output
To audio output Audio cable (RCA)
Signal cable
(BNC x 3 to D connector)
BNC cable
(BNC x 3 to BNC x 3)
BNC – RCA adaptor
Connecting a video device (component video/HDMI device)
This monitor can be connected to a video device equipped with component output such as a DVD player.
Refer to the user’s manual of the connected device for details. (Cables shown in the fi gure below are commercially available.)
• To connect a DVD player equipped with component output to the YPbPr IN connector on the monitor, use a BNC cable (BNC x 3
– BNC x 3) and a BNC – RCA adaptor (commercially available), or a signal cable (BNC x 3 – D connector).
Select [YPbPr] using the INPUT button on the monitor or the YPbPr button on the wireless remote control.
• To make audio connection, connect an audio cable (RCA) to the AUDIO IN2 connector or the AUDIO IN3 connector.
Select [AUDIO2] or [AUDIO3] using the AUDIO INPUT buttons on the wireless remote control.
• To connect a DVD player equipped with HDMI output to the HDMI IN connector on the monitor, use an HDMI signal cable.
Select [HDMI] using the INPUT button on the monitor or the HDMI button on the wireless remote control.
• For HDMI cable connection, select HDMI audio.
(You can select HDMI audio only when the video input is [HDMI].)
DVD player
(component device)
LCD monitor (rear)
DVD player
(HDMI device)
P-4 Connection procedure (continued)