beautypg.com

Osd screen functions (continued), Advanced option, English – MITSUBISHI ELECTRIC LDT462V User Manual

Page 55

background image

English-51

English

OSD screen functions (continued)

ADVANCED OPTION

INPUT RESOLUTION

* For the D-SUB inputs only.

If the monitor fails to recognize the input signal resolution
correctly, you can select a proper resolution manually.
Only when a signal having a resolution close to any of the
following values from three groups, the values in the most
appropriate group are selectable.
Group 1: AUTO, 1024 x 768, 1280 x 768, 1360 x 768

, 1366 x 768

Group 2: AUTO, 1400 x 1050, 1680 x 1050
Group 3: AUTO, 1600 x 1200, 1920 x 1200

BLACK LEVEL EXPANSION

* For the HDMI (Automatically selected depending on the

input signal.), DVI-D, OPTION (SDI), YPbPr, S-VIDEO,
and VIDEO inputs only.

Select the level of black expansion from OFF, MIDDLE, and
HIGH.

INPUT CHANGE

You can select the time for input switching from QUICK and
NORMAL.
NOTE: When you select QUICK, slight noise may appear.

INPUT DETECT

When two ore more computers or video devices are
connected, this function detects and automatically selects
an input video source.
AUTO SELECT

* For the DVI-D, D-SUB, and OPTION inputs only.

The DVI-D or D-SUB input port, either of which is carrying
a video signal, is automatically selected.
When no signal is present at either of them for 5 seconds,
the monitor enters the sleep mode.
When an extension module such as an SDI BOX is in the
option slot, DVI-D isn’t detected and OPTION is selected.
NOTE: Video signals carried by the HDMI, YPbPr,

S-VIDEO, VIDEO, and DisplayPort input ports
aren’t detected.

When an extension module is mounted, the
monitor doesn’t enter the sleep mode.

VIDEO DETECT

When the function detects a video signal carried by any
of the HDMI, YPbPr, S-VIDEO, and VIDEO input port, it
automatically selects the input port.
When the video signal being displayed is lost, any of the
D-SUB input ports previously selected was automatically
selected again.
NOTE: When an extension module is mounted, the

monitor doesn’t enter the sleep mode.

OFF

Video inputs aren’t selected automatically.

SCAN MODE

* For the HDMI, YPbPr, S-VIDEO, and VIDEO inputs only.

You can select the image display area.
OVERSCAN:

About 95% of the input image is displayed.

UNDERSCAN: Almost 100% of the input image is

displayed.

SCAN CONVERSION

* For the HDMI, YPbPr, S-VIDEO, and VIDEO inputs only.

You can select the IP conversion mode.
PROGRESSIVE: Interlace signals are converted into

progressive signals. Select this setting for
normal cases.

INTERLACE:

Interlace signals are displayed without
being converted. Though this setting is
suitable for motion images, still images
aren’t displayed properly.

FILM MODE

You can select the fi lm mode function.
AUTO: Images of 24 frames per second are detected,

subjected to interpolation, and then displayed.

OFF:

The input video signals are displayed without being
subjected to any processing.

NOTE: When FILM MODE is AUTO, set SCAN CONVERSION

to PROGRESSIVE. See page 51.