beautypg.com

P-2 installing the monitor, Using the wall mount or ceiling mount, Installing and removing the stands – MITSUBISHI ELECTRIC LDT462V User Manual

Page 18

background image

English-14

P-2

Installing the monitor

Carry out as necessary

Using the wall mount or ceiling mount

Lay the screen face down

Lay the protective sheet on a table, which was wrapped around

the monitor when it was packaged, beneath the screen surface

so as not to scratch the screen surface.

This device cannot be used or installed without the Tabletop

Stand or other mounting accessory. Failure to follow the correct

mounting procedures can result in damage to the equipment or

injury to the user or installer. Product warranty does not cover

damage caused by improper installation.

Failure to follow these recommendations can void your

warranty.

For installation, use M6 screws (with a loose-proof spring

washer and having a length 10 mm longer than the thickness of

the mounting bracket) and tighten them securely. MITSUBISHI

ELECTRIC recommends using mounting interface that comply

with TÜV-GS and UL1678 standard in North America.

100 100 100 100

545.5

545.5

200

323

323

CAUTION:

For preventing the monitor from falling.

• Install the monitor with metal brackets for wall or

ceiling installation (commercially available) on your own

responsibility. For detailed procedures of installation, refer

to the instructions of the metal brackets.

• To lessen the probability of injury and damage resulting

from fall of the monitor in case of earthquake or other

disaster, be sure to consult the bracket manufacturer for

installation location.

• To lessen the risk of falling of the monitor, thread

commercially available rope through the handles at the

right and left of the monitor and secure the rope to the

wall mount brackets or ceiling mount brackets. Use rope

that can bear a load 6 times the weight of the monitor

(approximately 150 kg).

• Do not sleep where the monitor may topple over or fall in

case of an earthquake or other disaster.

• Use screws having enough strength to support the LCD

display monitor (made of stainless steel etc.).

Handles

Protective Sheet

(mm)

Table

Installing and removing the stands

The stands are available as option.

Refer to the user’s manual of the stand for more information.

How to install the stands

1. Turn the monitor off.

2. Insert the option stands in the guide frames on both sides

to the end.

Secure the option stands on both sides fi rmly using the

screws supplied with the option stands.

3. Install the monitor on a fl at and stable surface.

NOTE:

• Install the stands so that their longer portions come to the

front.

How to remove the stands

1. Spread the protective sheet on a fl at surface, such as a

desk.

2. Place the monitor on the protective sheet.

3. Remove the screws to remove the option stands.

Option stand x 2

(Longer portion comes to the front.)

Screw x 2
(Accessories of
the option stand)