SUUNTO Advizor - Manual (Page 33)

27
8. At the minutes desired, PRESS the [Mode] button to accept the changes and exit the setup program. A small bell will
appear at the bottom left side in Field 2 to signify an alarm has been activated.
The Alarm setup is complete. To activate up to three alarms, please repeat steps 1-8 for the selected alarm (1, 2, or 3).
3.3 DUAL TIME SUB MODE
The Dual Time sub mode allows you to set the watch to display a time other than the main one.
In the TIME mode, PRESS the [Select] button twice to enter this sub mode.
In the dual time mode (Fig. 20):
• Field 1 displays “dUA” indicating “dual time”,
• Field 2 displays the current time, and
• Field 3 displays the dual time (e.g. your home time).
The user can display the seconds while in this sub mode by pressing the [+] button, in Field 3 the seconds will
appear for 10 seconds. Afterwards the display returns to showing the dual time.
3.3.1 Setting the Dual Time Function
In the dual time mode:
1. PRESS the [Select] button and hold in for 2 seconds. Located in Field 3, the hours will begin to flash.
2. PRESS the [+] button to scroll the hours upward or PRESS the [-] button to scroll the hours downward.
3. At the hour desired, PRESS the [Select] button to move to the next setting. Located in Field 3 to the right of the hour
value, the minutes will begin to flash.
4. PRESS the [+] button to scroll the minutes upward or PRESS the [-] button to scroll the minutes downward.
5. At the minutes desired, PRESS the [Mode] button to accept the changes and exit the setup program.
The dual time setup is complete.
The dual time stays the same, even though the time in the main time mode is adjusted. For example, if you set the dual
time to show your home time, your home time will always be displayed in this sub mode even though you travel to a different
time zone and adjust the time in the main time mode.