SUUNTO Advizor - Manual (Page 24)

18
2.7 STOPWATCH SUB MODE
The Wristop Computer stopwatch feature can provide split time measurement up to 23 hours 59 minutes and 59 seconds
up to 30 split times and heart rate readings can be stored into the HRM memory.
In the HRM mode, PRESS the [Select] button once to enter this submode.
In the Stopwatch mode (Fig. 4):
• Field 1 displays the seconds and tenths of a second,
• Field 2 displays the current heart rate, and
• Field 3 displays hours and minutes and to the far right “stopwatch”.
Note: When the transmitter is not worn, Field 2 displays the current time.
The HRM memory for one event is automatically activated when starting the stopwatch (or countdown timer). The memory
stores total training time, maximum, minimum and average heart rate during training, as well as time spent in, above and
below the target heart rate zone for one event. The next time the stopwatch (or countdown timer) is activated, the previous
event’s information will be erased.
2.7.1 How to Use the Stopwatch
There are three timing modes the user can employ:
• an elapsed time measurement;
• a split time measurement; and
• a finish time measurement for up to 30 runners.
In the elapsed time mode:
1. PRESS the [+] button to start, stop, and restart the stopwatch in the stopwatch sub mode.
2. PRESS the [-] button to reset the stopwatch to zero once the stopwatch has stopped.
In the split time mode:
1. PRESS the [+] button to start the stopwatch.
2. PRESS the [-] button once to stop the stopwatch and to display a split time. This split time and the momentaneous heart
rate reading will be stored in the memory for later viewing. The stopwatch will automatically start running after