Usage notice 3m™ super close projection system – 3M SCP717 User Manual
Page 9
4
© 3M 2008. All Rights Reserved.
Usage Notice
3M™ Super Close Projection System
WARNING
•
Lamp replacement caution. Before removing the screws, discon-
nect the power cable. Hot surface inside. Allow 1 hour to cool
before replacing the lamp. Handle with care. Risk of explosion.
See Owner's Manual.
•
Unplug the projector from the electrical outlet and allow the lamp
to cool for 60 minutes before replacing the lamp.
•
Wait at least 30 minutes for the lamp assembly to cool before
replacing.
•
Always handle the fragile lamp module with care.
•
In the event of a lamp rupture, call a 3M authorized service pro-
vider for repair. Ruptured lamp is not user serviceable.
•
Ventilate the area where the lamp rupture occurred. The lamp
operates at high pressure and temperature.
•
Replace the lamp module when the lamp replacement message
appears.
•
Never replace the lamp module with a previously used lamp
module.
•
Hg: Lamp contains mercury. Don't throw in trash. Dispose ac-
cording to local, state, or federal laws. See www.lamprecycle.org
or call 1-800-328-1371.
•
Wash your hands thoroughly if contact with ruptured lamp debris
has taken place.
•
Ventilate the area where the lamp rupture occurs. The lamp oper-
ates at high temperature.