beautypg.com

Powering on/off the projector, Powering on, Powering on the projector – 3M SCP717 User Manual

Page 20: 3m™ super close projection system installation

background image

© 3M 2008. All Rights Reserved.

15

3M™ Super Close Projection System

Installation

Powering On the Projector

1. Ensure that the power cord and signal cable are securely

connected. The Power LED will turn red.

2. Turn on the lamp by pressing “Power/Standby” button on the

control panel. And the Power LED will turn blue.

3. Turn on your source (computer, notebook, video player,

etc.). The projector should automatically detect your source

within “Management” menu; check that “Input Source” has

been set to “Auto Searching”.

To access the built-in test pattern, please press the “Blank”

button, then up arrow.

If you connect multiple sources at the same time, use the

“Source” button on the control panel or direct source key on

remote control to switch.

Powering On/Off the Projector

Power/Standby

Turn on the

projector first and

then the signal

sources.

Test Pattern

1

1

This manual is related to the following products: