3M SCP717 - Manual (Page 8)

© 3M 2008. All Rights Reserved. 3
3M™ Super Close Projection System Usage Notice
WARNING
• Do not attempt to service the projector other than performing
routine lamp replacement. Service should only be performed by
a 3M authorized service provider. Aside from the projection lamp
assembly, there are no serviceable parts inside the unit.
• Contact a 3M authorized service provider for service.
• Do not modify this projector.
• Do not allow water or other liquids to enter the projector.
• Do not operate this projector in wet environments or outdoors.
• Do not use this projector around unsupervised children.
• Replace power cord if damaged.
• Contact a 3M authorized service provider if the projector be-
comes damaged.
• Connect this projector into a grounded outlet.
• Use a grounded extension cord with a rating at least equal to that
of the projector.
• Use only the 3M brand wall mounting hardware kit if wall mount-
ing is desired.
- Installation of 3M wall kit must only be performed by qualified
personnel.
- Adhere strictly to the proper installation procedure as outlined in
the installation instructions when installing the 3M wall kit.
• Always operate the unit on a flat, sturdy, and horizontal surface.
• Before operating, please read owner's manual. Do not remove
screws except lamp cover screws. Do not block venting open-
ings.