3m™ super close projection system appendices – 3M SCP717 User Manual
Page 50
© 3M 2008. All Rights Reserved.
45
3M™ Super Close Projection System
Appendices
Message
Power-LED
Temp-LED Lamp-LED
(Blue)
(Red)
Standby State
(Plug in power cord)
Warming
Flashing
Normal Mode
Cooling
Flashing
Error (Lamp failed)
Error (Fan failed)
Flashing
Error (Over Temp.)
Problem: Image is out of focus
Adjust the Focus Ring on the projector lens.
Make sure the projection screen. (see pages 18-19)
Problem: The image is stretched when displaying 16:9 DVD
The projector automatically detects 16:9 DVD and adjusts the aspect
ratio by digitizing to full screen with 4:3 default setting.
If the image is still stretched, you will also need to adjust the aspect
ratio by referring to the following:
Please select 4:3 aspect ratio type on your DVD player if you are
playing a 16:9 DVD.
If you can’t select 4:3 aspect ratio type on your DVD player, please
select 4:3 aspect ratio in the on screen menu.
Problem: Image is reversed
Select “Management-2/3 Mounting or Rear” from the OSD and
adjust the projection direction. (see page 29)
Problem: Lamp burns out or makes a popping sound
When the lamp reaches its end of life, it will burn out and may
make a loud popping sound. If this happens, the projector will not
turn on until the lamp module has been replaced. To replace the
lamp, follow the procedures in the “Replacing the Lamp”.
(see page 47)
Problem: LED lighting message
•
Steady light
No light