beautypg.com

Replacing the lamp, 3m™ super close projection system appendices – 3M SCP717 User Manual

Page 52

background image

© 3M 2008. All Rights Reserved.

47

3M™ Super Close Projection System

Appendices

Replacing the Lamp

The projector keeps track of the lamp usage. It will show

you a warning message:

When you see this message, change the lamp as soon as

possible. Make sure the projector has cooled down for at

least 30 minutes before changing the lamp.

Lamp Replacement Procedure:

1. Turn off the power by pressing the Power/Standby button.
2. Allow the projector to cool down for at least 30 minutes.
3. Disconnect the power cord.
4. Use a screwdriver to unscrew the 2 screws from the cover.
5. Push up and remove the cover.
6. Use a screwdriver to unscrew the 2 screws from the lamp

module.

7. Pull up the lamp handle carefully. 
8. Remove the lamp module. 
To replace the lamp module, reverse the previous steps.

Warning: Lamp

compartment is hot!

Allow 30 minutes to

cool down before

changing lamp!

Warning: To reduce

the risk of personal

injury, do not drop

the lamp module

or touch the lamp

bulb. The bulb

may shatter and

cause injury if it is

dropped.

1

3

4

5

2

This manual is related to the following products: