beautypg.com

Powering off, Led indicator, Powering off the projector led indicator – 3M SCP717 User Manual

Page 21: Powering off the projector, Installation 3m™ super close projection system

background image

16

© 3M 2008. All Rights Reserved.

Installation

3M™ Super Close Projection System

LED Indicator

When the “TEMP” indicator turns red, it indicates the

projector has overheated. The projector will automatically

shut itself down.

When the “LAMP” indicator turns red, it indicates a problem

with the lamp. Turn off the projector and disconnect the

power cord from the electrical outlet, then contact your local

dealer or our service center.

When the “LAMP” indicator flashes red, it indicates the

fan has failed. Stop using the projector and disconnect the

power cord from the electrical outlet, then contact your local

dealer or our service center.

Powering Off the Projector

1. Press the “Power/Standby” button to turn off the projector

lamp; you will see a message

displayed on the projecor’s screen. Press the “Power/

Standby” button again to confirm.

2. The cooling fans continue to operate for about 2 minutes for

cooling cycle and the Power LED will flash red. When the

Power LED stops flashing, the projector has entered standby

mode.

Once in standby mode, simply press “Power/Standby” button

to restart the projector.

3. Disconnect the power cord from the electrical outlet and the

projector.

4. Following a power off procedure, please allow 2 minutes

before attempting to restart the projector.

This manual is related to the following products: