ZyXEL Communications P-660R-D Series - Manual (Page 185)

P-660R-D Series User’s Guide
Appendix F Command Interpreter 1
A
P P E N D I X
F
Command Interpreter
The following describes how to use the command interpreter. You can telnet to access the CLI (Command
Line Interface) on the ZyXEL Device. See the included disk or zyxel.com for more detailed information on
these commands.
Note: Use of undocumented commands or misconfiguration can damage the unit and possibly
render it unusable.
Accessing the CLI
Use the following steps to telnet into your ZyXEL Device.
1 Connect your computer to the ETHERNET port on the ZyXEL Device.
2 Make sure your computer IP address and the ZyXEL Device IP address are on the same subnet. In
Windows, click Start (usually in the bottom left corner), Run and then type telnet 192.168.1.1
(the default ZyXEL Device IP address) and click OK.
3 A login screen displays. Enter the default admin password "1234".
Command Syntax
• The command keywords are in courier new font.
• Enter the command keywords exactly as shown, do not abbreviate.
• The required fields in a command are enclosed in angle brackets <>.
• The optional fields in a command are enclosed in square brackets [].
• The |symbol means or.
For example,
sys filter netbios config
means that you must specify the type of netbios filter and whether to turn it on or off.
Command Usage
A list of valid commands can be found by typing help or? at the command prompt. Always type the full
command. Type exit to log out of the CLI when finished.