10 bandwidth management monitor – ZyXEL Communications NBG334SH User Manual
Page 146

Chapter 14 Bandwidth Management
ZyXEL NBG-334SH User’s Guide
146
Figure 81 Bandwidth Management Rule Configuration: User-defined Service
The following table describes the labels in this screen.
14.10 Bandwidth Management Monitor
Click Management > Bandwidth MGMT > Monitor to open the bandwidth management
Monitor screen. View the bandwidth usage of the WAN configured bandwidth rules. This is
also shown as bandwidth usage over the bandwidth budget for each rule. The gray section of
the bar represents the percentage of unused bandwidth and the blue color represents the
percentage of bandwidth in use.
Table 60 Bandwidth Management Rule Configuration: User-defined Service
LABEL
DESCRIPTION
BW Budget
Select Maximum Bandwidth or Minimum Bandwidth and specify the maximum
or minimum bandwidth allowed for the rule in kilobits per second.
Destination
Address
Enter the destination IP address in dotted decimal notation.
Destination
Subnet Netmask
Enter the destination subnet mask. This field is N/A if you do not specify a
Destination Address. Refer to the appendices for more information on IP
subnetting.
Destination Port
Enter the port number of the destination. See
for some
common services and port numbers.
Source Address
Enter the source IP address in dotted decimal notation.
Source Subnet
Netmask
Enter the destination subnet mask. This field is N/A if you do not specify a Source
Address. Refer to the appendices for more information on IP subnetting.
Source Port
Enter the port number of the source. See
for some common
services and port numbers.
Protocol
Select the protocol (TCP or UDP) or select User defined and enter the protocol
(service type) number.
OK
Click OK to save your customized settings.
Cancel
Click Cancel to exit this screen without saving.