ZyXEL Communications ZyXEL ZyAIR A-6000 - Manual (Page 35)

A-6000 High Speed, Long Range Ethernet Wireless Bridge
CLI commands 4-2
-> get gateway
Gateway IP Address:
-> set gateway 192.168.0.1
Gateway IP Address: 192.168.0.1
(5) To display hardware
Use the get hardware command to display the vendor ID and chip (MAC, PHY and analog) revisions.
-> get hardware
PCI Vendor ID: 0x168c, Device ID: 0x207, Sub Vendor ID: 04, Sub Device
ID: 0
WLAN revisions: mac 3.0 phy 2.0 analog 1.6
(6) To display platform hardware version
Use the get hardware command to display the vendor ID and chip (MAC, PHY and analog) revisions.
-> get hw_ver
A-6000 System Hardware Platform: 1.00a
(7) To display/modify IP address
Use the get/set ipaddr command to display or modify the basestation unit IP address.
-> get ipaddr
IP Address: 192.168.1.20
-> set ipaddr 192.168.1.40
IP Address: 192.168.1.40
(8) To display/modify IP subnet mask
Use the get/set ipmask command to display or modify the basestation unit IP subnet mask.
-> get ipmask
IP Subnet Mask: 255.255.255.0
-> set ipmask 255.255.0.0
IP Subnet Mask: 255.255.0.0
(9) To display security policy
Use the set security command to view or modify the authentication type.
wlan0 -> get security
Security Policy: AES.
wlan0 -> set security TKIP
Security Policy: TKIP
(10) To modify security policy
Use the set security command to view or modify the authentication type.
wlan0 -> set security AES
Security Policy: AES.
wlan0 -> set security TKIP
Security Policy: TKIP
(11) Security Key Configuration
Sets the PSK passphrase. Hit return at the old passphrase prompt and enter the new passphrase. Maximum is
63 characters. For examples:
-> set passphrase
Old PassPhrase: 12345678
(12) System Configuration
Following table lists the steps to configure the system. Remember to reboot the system to make configuration
works.
Command Description
set factory Sets the BU to factory defaults.
set ipaddr <IP Address> Sets the IP address of the BU ethernet interface