Zebra Technologies ZEBRA Z4M H-974 - Manual (Page 41)

H-974
PAGE 41 OF 57 0808 IH-974
Cleaning
This table provides a recommended cleaning schedule. Specific cleaning procedures
are provided on the following pages.
CAUTION: Use only the cleaning agents indicated. Zebra Technologies
Corporation will not be responsible for damage caused by any other
cleaning fluids used on this printer.
Zebra Z4M Printer User’s Guide 55
Routine Care and Adjustments
Area Method Interval
Printhead Solvent* After every roll of media (or 500 feet of
fanfold media) when printing in the direct
thermal mode.
After every roll of ribbon or three rolls of
media when printing in the thermal
transfer mode.
These intervals are intended as guidelines
only. You may have to clean more often,
depending upon your application and
media.
Platen roller Solvent*
Media sensors Air blow
Ribbon sensor Air blow
Media path Solvent*
Ribbon path Solvent*
Pinch roller (Optional value peel-off
option required. See Figure 25.)
Solvent*
Cutter
module
If cutting continuous,
pressure-sensitive media
Citrus-based
adhesive
remover After every roll of media (or more often,
depending upon your application and
media).
If cutting tag stock or label
backing material Solvent* and
air blow
After every two or three rolls of media.
Tear-off/peel-off bar Solvent* Once a month.
Take label sensor Air blow Once every six months.
*Zebra recommends using a solvent containing 90% isopropyl alcohol.