Zebra Technologies ZEBRA Z4M H-974 - Manual (Page 10)

H-974
PAGE 10 OF 57 0808 IH-974
Configuring the Software of Printer Driver
Many printer settings may also be controlled by your printer’s driver or label
preparation software. Refer to the driver or software documentation for more
information.
Printing a Test Label
To print a test label:
1. Turn off the printer.
2. Press and hold the CANCEL key while
turning on the printer.
3. Release the key after the DATA light turns
off (approximately five seconds).
A configuration label, which shows the printer’s
currently stored parameters, will print (similar to
the one shown in Figure 10).
If you encounter any problems while you are
configuring the printer or printing a test label,
refer to Troubleshooting, which starts on
page 67. Otherwise, refer to Establishing
Communication on page 17 to set up the
communication parameters.
16 Zebra Z4M Printer User’s Guide
Figure 10