Zenith Data Systems MT2000 - Manual (Page 110)

5-22
Upgrades and Options
Figure 5-8. Non-Volatile Memory Location
Rep l aci n g t h e No n - V o l at i l e M emo ry
Notice: Observe static precautions. Use an antistatic
wrist strap.
1. Power off the system and remove the side panel as
described earlier in this chapter.
2. Using a IC removal tool or a small pointed tool,
gently pry up each end of the non-volatile memory
and pull it straight up out of its socket (Figure 5-8).
3. Orient the new chip over its socket so the dot is
properly oriented. Carefully insert the chip into its
socket connectors.
4. Press down on the chip until it is firmly seated in its
socket.
5. Replace the side panel and turn on the system.
6. Run the BIOS SETUP and SCU to restore proper
configuration settings.