Zenith Data Systems MT2000 - Manual (Page 100)

5-12
Upgrades and Options
Pentium Pro Processor
The processor/memory board has two sockets for
Pentium Pro Processors.
I n st al l i n g a P ro cesso r
Figure 5-4 illustrates the location for the optional
Pentium processor in your system. When adding a
second processor, use
the same type and speed as the
processor shipped with your system. Contact your sales
representative.
Notice: Installing a second processor that is of a
different type than the first processor, will result in
system damage. Do not touch or bend the processor's
exposed pins.
The processor upgrade kit contains a DC to DC
converter board, processor chip, and heat sink. The
heat sink has a heat transfer pad on the bottom and
two attached retention clips. To install the second
Pentium Pro processor upgrade kit:
1. Remove the processor/memory board as described
earlier in this section.
Notice: Observe static precautions. Use an antistatic
wrist strap.
Note: Verify that the jumper on the processor/memory
board (see Figure 5-4) is set for the correct processor
speed. Jumper pins 2 and 3 for 200 MHz and pins 1 and
2 for 180 MHz.
2. Raise the lever on the ZIF socket to the up position
(Figure 5-4, A).