Xantrex Technology 400R - Manual (Page 53)

Replacing the Incandescent Light
975-0162-01-01 4-9
5. Securely fasten the bolt and washer that holds the red
positive (+) cable to the positive (+) battery terminal and
the black negative (–) cable to the negative (–) battery
terminal.
6. Do not overtighten the bolt. Consult the battery
manufacturer for torque specifications.
7. On the XPower Powerpack, replace the battery cover and
the four fasteners.
8. Dispose of the old battery in an environmentally
responsible manner.
Replacing the Incandescent Light
To replace a light bulb:
1. Turn the light switch off.
2. Unscrew the cover and lens.
3. Gently grasp the bulb and pull to remove the light
reflector assembly and the bulb.
4. While holding the light reflector assembly, gently
unscrew the black knob at the back of the assembly.
5. Remove the old bulb and insert a replacement bulb of the
same type and rating into the light reflector assembly.
6. Holding the light reflector assembly, gently screw the
black knob on to the back of the assembly.
7. Reattach the lens and cover.