Xantrex Technology 400R - Manual (Page 41)

Using the Radio: XPower Powerpack 400R
975-0162-01-01 3-15
To inflate small sports equipment:
1. Place the valve connector fully on or into the valve
receptacle on the item. Go to Step 4.
OR
If necessary, use a supplied nozzle adaptor.
2. Choose the appropriate nozzle adaptor, insert the nozzle
adaptor into the valve stem and close the thumb latch.
3. Insert nozzle adaptor into the valve receptacle of the
item.
4. Turn the compressor on and inflate to appropriate
pressure.
5. Turn the compressor OFF before removing nozzle adaptor
from valve stem.
6. Remove nozzle adaptor from valve connector and store
in storage compartment.
Using the Radio: XPower Powerpack 400R
For information about operating the radio, see page 2–5.
CAUTION
The XPower Powerpack cannot be used to inflate large capacity
inflatables such as float tubes, large air mattresses, and inflatable
boats. These types of products require extended inflating times
which may damage the compressor.
WARNING: Fire hazard
Allow the compressor to cool down for 10 minutes after each 10
minutes of continuous operation.
Note :
Leave the thumb latch in the open position for storing to
relieve pressure on the internal mechanism.