Zebra Technologies ZEBRA QL UMAN-QLP-001 - Manual (Page 68)

68
QL Plus Series User Guide
Label Specifications
Parameter QL220 Plus QL 320 Plus QL 420 Plus
Label or Tag Width
0.75 in. to 2.12 in.
(16 to 53.8 mm) 1.5 in. to 3.1 in.
(38.1 to 78.4 mm) 2 in. to 4.1
in. (50.8 to
104.1 mm)
Max. Label/ Tag Length
(w/std. memory) 20 in. (508 mm) 16 in. (406.4 mm) 20 in. (508 mm)
Inter-label Gap.
0.08 in. to 0.16 in. (.12 in. preferred)
(2 mm to 4 mm, 3 mm preferred)
Label Thickness 0.0025 in to 0.0065 in (0.064 mm to .165 mm)
Tag Thickness 0.0060 in. (0.152 mm) maximum
Max. Label Roll dia.
2.20 (55.8 mm)
O.D.
2.63 in. (66.8 mm) O.D.
Label Inner Core
0.75 in. (19 mm) minimum dia;
1.38 in. (35.05 mm) minimum dia. for linerless media
(QL 420 Plus accepts linerless media on 0.75 in. cores.)
Black Mark Dimensions
The reflective media black marks should extend past
the center-line of the roll.
Media Requirements
Minimum mark width: 0.5 in. (12.7 mm) perpendicular
to edge of media, centered within the width of the
roll.
Mark length: 0.094 in. (2.4 mm) parallel to edge of
media
Use Zebra brand direct thermal media that is outside wound. Media
may be reflective (black mark) sensing, or transmissive (gap) sensing,
die-cut, continuous, or linerless. QL 420 Plus models will accept
fanfold media if used with an external media supply.
For die-cut labels, use only full auto dies.