Zebra Technologies ZEBRA QL UMAN-QLP-001 - Manual (Page 11)

11
QL Plus Series User Guide
Getting Ready to Print
Battery
Installing the Battery
Important • Batteries are shipped partially charged. Remove
protective shrink-wrap and labels from new battery packs prior to
use.
1. Rotate the belt clip to allow access to the battery com-
partment.
2. Insert the battery into the printer as shown in Figure 2.
3. Rock the battery into the printer as shown until it locks in
place.
When the battery is first installed, the control panel indica-
tors may briefly turn on and then go off which indicates the
battery is not fully charged (see “Charging the Battery” below
and “Operator Controls”).
You must charge the batteries fully before using them for
the first time. To ensure maximum battery capacity, new bat-
teries should go through two or three complete charge/dis-
charge cycles when first put into service.
Figure 2: Installing the Battery
Belt Clip
Charger Jack
Battery
Battery
Charger Jack
Belt Clip
QL 420 Plus
QL 320 Plus
QL 220 Plus
Belt Clip