Zebra Technologies P520 - Manual (Page 44)

TROUBLESHOOTING 34
B • About the Laminator Station
SCREEN MESSAGE
INITIALISING
READY
COVER OPEN
ROTATION ERROR
LAMINATING
OUT OF RIBBON
MECHANICAL ERR
TEMPERATURE ERR
WARMING UP
RIBBON FAILURE
STANDBY MODE
MEANING
The printer is performing
an internal test before use
Ready for use
The cover is open
The printer has an error
moving the card in the flip
The printer is processing a
lamination
The printer ribbon has run
out
the printer has an error
moving the card internally
The printer has detected a
temperature error
A lamination command has
been sent and the tempera-
ture has not reached +/- 7°C
of the recommended temp.
The film is glud to the card
during the cool down
period.
Laminator power reduced.
ACTION
Wait for the ready message
Close cover
Remove card
Wait for the laminated card
Load a new ribbon
Remove the jamed card.
Ensure the card is not out of
specification.
Proceed an initialization by
switching Off and On.
Wait until the printer has
reached the recommended
temperature
Open laminator bracket.
Remove card.
Close laminator bracket.