Zebra Technologies P520 - Manual (Page 14)

1 • 3 Printer Installation
The following will guide you through the installation of your P520 printer.
CAUTION: Limit AC power supplied to the P520
Printer to 110 - 230 V AC, 60 - 50 Hz for an
associated 1,40A - 0,80A. Limit excess current
draw to 16 amps or less, using an associated
circuit breaker or other such device. Never operate
the printer in a location where operator, computer,
or printer can get wet. Personal injury could result.
T
h e
printer must be connected to an earthed electrical
power supply and properly protected against
electrical surges and grounding faults.
1 • Place the printer in a location that allows easy
access to all sides. The printer should never be
operated while resting on its side or upside down.
2 • Place the printer’s power switch in the OFF (O)
position.
3 • Insert the power cable to the printer power
socket and attach to grounded electrical socket of
the proper voltage and type.
4 • Attach interface cable to printer and computer
and then secure.
5 • Switch power on.
CAUTION: Intermittent or unpredictable operation
may occur from unsecured connectors. If
damaged, the power cable must be replaced by an
exact equivalent.
Use only Parallel Cable under 3 Meters in length.
3
4
GETTING STARTED 4