FujiFilm FinePix Real 3D V3 - Manual (Page 2)

ii
IMPORTANT SAFETY INSTRUCTIONS
• Read Instructions: All the safety
and operating instructions
should be read before the ap-
pliance is operated.
• Retain Instructions: The safety
and operating instructions
should be retained for future
reference.
• Heed Warnings: All warnings on
the appliance and in the op-
erating instructions should be
adhered to.
• Follow Instructions: All operating
and use instructions should be
followed.
Installation Installation
Power Sources: This video prod-
uct should be operated only
from the type of power source
indicated on the marking label.
If you are not sure of the type
of power supply to your home,
consult your appliance dealer or
local power company. For video
products intended to operate
from battery power, or other
sources, refer to the operating
instructions.
Grounding or Polarization: This
video product is equipped with
a polarized alternating-current
line plug (a plug having one
blade wider than the other).
This plug will fi t into the power
outlet only one way. This is a
safety feature. If you are unable
to insert the plug fully into the
outlet, try reversing the plug.
If the plug should still fail to fi t,
contact your electrician to re-
place your obsolete outlet. Do
not defeat the safety purpose of
the polarized plug.
Alternate Warnings: This video
product is equipped with a
three-wire grounding-type plug,
a plug having a third (grounding)
pin. This plug will only fi t into a
grounding-type power outlet.
This is a safety feature. If you are
unable to insert the plug into the
outlet, contact your electrician to
replace your obsolete outlet. Do
not defeat the safety purpose of
the grounding type plug.
Overloading: Do not overload
wall outlets and extension
cords as this can result in a risk
of fi re or electric shock.
Ventilation: Slots and openings
in the cabinet are provided for
ventilation, to ensure reliable
operation of the video product
and to protect it from overheat-
ing, and these openings must
not be blocked or covered.
The openings should never be
blocked by placing the video
product on a bed, sofa, rug, or
other similar surface.
This video product should not
be placed in a built-in instal-
lation such as a bookcase or
rack unless proper ventilation is
provided or the manufacturer’s
instructions have been adhered
to. This video product should
never be placed near or over a
radiator or heat register.
Attachments: Do not use attach-
ments not recommended by
the video product manufac-
turer as they may cause hazards.
Water and Moisture: Do not use
this video product near wa-
ter—for example, near a bath
tub, wash bowl, kitchen sink, or
laundry tub, in a wet basement,
or near a swimming pool, and
the like (excluding waterproof
products).
Power-Cord Protection: Power-
supply cords should be routed
so that they are not likely to be
walked on or pinched by items
placed upon or against them,
paying particular attention to
cords at plugs, convenience re-
ceptacles, and the point where
they exit from the appliance.
Accessories: Do not place this
video product on an unstable
cart, stand, tripod, bracket, or
table. The video product may
fall, causing serious injury to a
child or adult, and serious dam-
age to the appliance. Use only
with a cart, stand, tripod, brack-
et, or table recommended by
the manufacturer, or sold with
the video product. Any mount-
ing of the appliance should fol-
low the manufacturer’s instruc-
tions, and should use a
mounting accessory recom-
mended by the manufacturer.
An appliance
and cart
combination
should be
moved with
care. Quick
stops, excessive force, and un-
even surfaces may cause the
appliance and cart combination
to overturn.
Antennas Antennas
Outdoor Antenna Grounding: If an
outside antenna or cable sys-
tem is connected to the video
product, be sure the antenna
or cable system is grounded
so as to provide some protec-
tion against voltage surges and
built-up static charges. Section
810 of the National Electrical
Code, ANSI/NFPA No. 70, pro-
vides information with respect
to proper grounding of the
mast and supporting structure,
grounding of the lead-in wire
to an antenna discharge unit,
size of grounding conductors,
location of antenna discharge
unit, connection to grounding
electrodes, and requirements
for the grounding electrode.
EXAMPLE OF ANTENNA GROUNDING
AS PER NATIONAL ELECTRICAL CODE
Ground Clamp Antenna Lead
in Wire
Grounding
Conductors (NEC
SECTION 810-21)
Power Service Grounding
Electrode System (NEC ART
250. PART H)
Ground Clamps
Antenna
Discharge Unit
(NEC SECTION
810-20)
Electric Service
Equipment
Power Lines: An outside antenna
system should not be located in
the vicinity of overhead power
lines or other electric light or
power circuits, or where it can
fall into such power lines or
circuits. When installing an out-
side antenna system, extreme
care should be taken to keep
from touching such power lines
or circuits as contact with them
might be fatal.
Use Use
Cleaning: Unplug this video
product from the wall outlet
before cleaning. Do not use liq-
uid cleaners or aerosol cleaners.
Use a damp cloth for cleaning.
Object and Liquid Entry: Never push
objects of any kind into this
video product through open-
ings as they may touch danger-
ous voltage points or short out
parts that could result in a fi re or
electric shock. Never spill liquid
of any kind on the video product
(excluding waterproof products).
Lightning: For added protection
for this video product receiver
during a lightning storm, or when
it is left unattended and unused
for long periods of time, unplug it
from the wall outlet and discon-
nect the antenna or cable system.
This will prevent damage to the
video product due to lightning
and power-line surges.
Service Service
Servicing: Do not attempt to ser-
vice this video product yourself
as opening or removing covers
may expose you to dangerous
voltage or other hazards. Refer
all servicing to qualifi ed service
personnel.
Damage Requiring Service: Unplug
this video product from the
wall outlet and refer servicing
to qualifi ed service personnel
under the following conditions:
• When the power-supply cord
or plug is damaged.
• If liquid has been spilled, or
objects have fallen into the
video product.
• If the video product has been
exposed to rain or water (ex-
cluding waterproof products).
• If the video product has been
dropped or the cabinet has
been damaged.
If the video product does not
operate normally follow the op-
erating instructions. Adjust only
those controls that are covered
by the operating instructions
as an improper adjustment of
other controls may result in
damage and will often require
extensive work by a qualifi ed
technician to restore the video
product to its normal operation.
When the video product exhib-
its a distinct change in perfor-
mance—this indicates a need
for service.
Replacement Parts: When replace-
ment parts are required, be sure
the service technician has used
replacement parts specifi
ed
by the manufacturer or have
the same characteristics as the
original part. Unauthorized
substitutions may result in fi re,
electric shock or other hazards.
Safety Check: Upon completion
of any service or repairs to this
video product, ask the service
technician to perform safety
checks to determine that the
video product is in proper oper-
ating condition.
For Your Safety For Your Safety