Front panel lights 30, Roll media loading, Tear-off mode – Zebra Technologies R-140 User Manual

Page 40

Roll Media Loading

NOTE: A calibration must be performed when media and ribbon (if used)

are first installed in the printer, or when a different type of media

or ribbon is being used.

Tear-Off Mode

Refer to Figure 15.

1. Open the printhead.
2. Slide the media guide and media supply guide as far from the printer

frame as possible. Flip down the media supply guide.

3. Load media as shown.
4. Flip up the media supply guide. Slide in the media guide and media

supply guide so they just touch, but not restrict, the edge of the roll.

5. Close the printhead.

Zebra R-140 User’s Guide

Figure 15