Configuring the software or printer driver 20, Printer driver con fig u ra tion 20, Soft ware con fig u ra tion 20 – Zebra Technologies R-140 User Manual

Page 30: Media and ribbon calibration

Media and Ribbon Calibration

NOTE: All steps must be performed in the following procedure, even if

only one sensor needs to be adjusted.

6. Press the SETUP/EXIT key.
7. Press the NEXT/SAVE key until “MEDIA AND RIBBON

CALIBRATE” displays.

8. To start the calibration procedure, press the RIGHT BLACK OVAL

key. “LOAD BACKING CANCEL CONTINUE” displays.

9. Open the printhead. Remove approximately 8” (203 mm) of labels

from the media roll, enough so that only the backing material is

threaded between the media sensors when the media is loaded

(refer to Figure 10).

Zebra R-140 User’s Guide

Figure 10