Zebra ZM400 - Manual (Page 31)

23 Printer Setup
Connect the Printer to a Power Source
3/27/07 ZM400/ZM600 User Guide 79695L-001 Rev. A
Connect the Printer to a Power Source
The AC power cord must have a three-prong female connector on one end that plugs into the
mating AC power connector at the rear of the printer. If a power cable was not included with
your printer, refer to
Power Cord Specifications on page 24 .
To connect the printer to a power source, complete these steps:
1. Toggle the printer power switch to the off ( O ) position.
2. Plug the power cord into the AC power connector (
1
) on the rear of the printer.
3. Plug the other end of the power cord into a power outlet near the printer.
4. Turn on ( I ) the printer.
The control panel LCD and lights activate, indicating that the printer is booting up.
Caution • For personnel and equipment safety, always use an approved three-conductor
power cord specific to the region or country intended for installation. This cord must use an
IEC 320 female connector and the appropriate region-specific three-conductor grounded
plug configuration.
1