Zebra Technologies ZebraNet ZM400TM - Manual (Page 34)

Getting Started
Before You Begin 34
14197L-001 Rev. A ZebraNet
®
10/100 Internal Print Server for ZM400 and ZM600 User Guide 04/19/2007
Before You Begin
10/100 Internal PS offers many features, but how you access and work with them is dependent
on your environment. Before you begin, you need to get information from the 10/100 Internal
PS configuration label.
Table 3 shows the minimum label widths needed to print a 10/100 Internal PS configuration
label with different DPI printheads.
To print a network configuration label for the ZM400 or ZM600 with a
10/100 Internal PS, complete these steps:
1. Turn on ( I ) the printer and let it complete its power-up cycle.
When the POST cycle is complete, press Setup/Exit to enter the Setup Mode.
2. Scroll through the parameters using the Plus ( + key) until you reach List Network.
3. Press Plus ( + key) to print the network configuration label.
Important • Make sure the printer is turned off ( O ).
Table 3 • Label Width
DPI Inches MM
600 1.25 31.75
300 2.50 63.50
200 3.69 93.73