Xerox 96 - Manual (Page 38)

USER INTERFACE
3-2 XEROX DOCUPRINT 96/4635/180 IPS SYSTEM OVERVIEW GUIDE
Graphical user interface screen
After you power on the HCU (if appropriate) and the Sun workstation,
the Printer Controller monitor displays three windows:
•
IPS main window
•
IPS Console window
• IPS Print Engine Monitor window.
The IPS main window is the largest window on the screen. The main
window displays the current system setup, the current system status,
and any jobs that are running. This window also provides access to
menus and subwindows from which you can configure and operate
your system.
The IPS Console window displays messages that warn you of
Printer Controller problems. (This window initially displays below the
IPS main window on the left, but it can be moved where desired.)
Note: High frequency service indicator (HFSI) messages may
appear occasionally in this window. These messages do not indicate
any problem, merely that you should advise your service
representative to check the indicated areas during the next service
call.
The IPS Print Engine Monitor window shows printer error
messages, indicates the printer status and displays printer and DFA
messages. (This window initially displays below the IPS main window
on the right, but it can be moved where desired.)
The following figure shows these windows on the screen of the
Printer Controller monitor.