Yamaha CVP-59S - Manual (Page 52)

49
Custom Style
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
• During Custom Style recording, no
MIXER display is available.
Once the required quantize size has been selected press the START
LCD button to actually quantize the current part. Playback will stop for
an instant while the data is being quantized, then the
START LCD button
will change to UNDO , allowing you to undo the quantize operation and
return to the pre-quantized data if the results are not as you expected.
You will not be able to UNDO once another button has been pressed.
<
Repeat Until the Custom Style is Complete
........................
Repeat steps 3 through 7 until all parts or all sections have been re-
corded as required.
• Quantization can only be applied to the
current recording part. Quantization
cannot be executed if no part is set to
the record mode.
>
Name the Custom Style
.............................................................................
When your custom style is complete, use the PAGE buttons to select
CUSTOM STYLE page 3, and press the STYLE NAME LCD button to
go to the style naming page.
The current style name appears in the upper right corner of the dis-
play. Use the > LCD button to position the underline cursor at the char-
acter you want to change (style names can be up to 12 characters in
length). Use the data dial and/or the [+]/[–] buttons to select the charac-
ter you want to enter from the list in the center of the display, then press
the
c.set LCD button to enter the character at the current cursor posi-
tion. Repeat this procedure until your name is complete. The c.del LCD
button can be used to back up one space and delete a character.
When the name is complete press the OK LCD button to register the
name for the current custom style, or CANCEL to abort.