SUUNTO Gekko - Manual (Page 23)

21
All information on the display is labeled (Fig. 3.6).
During a no-decompression stop dive, the following
information will be displayed:
- your present depth in meters [ft]
- the maximum depth during this dive in meters
[ft], indicated as MAX
- the available no-decompression time in minutes
in the center window as NO DEC TIME and as
a bar graph on the left side of the display. It is
calculated based on the fi ve factors described
in section 6.1. “Operating Principles”.
- the water in temperature in °C [°F] in the lower
left corner
- the elapsed dive time in minutes, shown as
DIVE TIME in the lower right corner
- the Altitude Adjustment setting on the left side
of the center window with a wave and moun-
tain symbols (A0, A1, or A2) (see Table 3.4.)
- the Personal Adjustment setting on the left side
of the center window with a diver symbol and
+ signs (P0, P1, or P2) (see Table 3.5.)
- Diver Attention Symbol if there is micro-
bubble buildup, and surface interval should be
prolonged (see Table 3.3.)
Alternative displays by pressing the TIME button
(Fig. 3.7.):
- the current time, shown as TIME
NOTE!
In Dive Mode the alternative display switch-
es back to the main display after 5 seconds.
3.3.2. BOOKMARK
It is possible to make special marks in the profi le
memory during a dive. These Bookmarks will be
shown as a blinking dive log symbol when scrolling
the profi le memory on the computer display. To make
a bookmark on the profi le memory during a dive press
the PLAN button (Fig. 3.8.).
Fig. 3.8. Bookmark activa-
tion. An annotation, Book-
mark, is placed in the profi le
memory during a dive by
pressing PLAN button. Note
Logbook symbol.
m
NO DEC TIME
T
C
B
° C
MAX
DIVE TIME
MAX
Fig. 3.9. A three minute Rec-
ommended Safety Stop.
DIVE TIME T
C
B
° C
m
STOP
MAX
Fig. 3.10. Ascent Rate Indi-
cator. Three segments.
m
NO DEC TIME
T
C
B
° C
MAX
DIVE TIME