Zebra Technologies TTP 8000 User Manual
Page 80
Default Parameter Settings
Print Setup
80
P1003638-003
TTP 8000 Technical Manual
10/19/2009
Decides if the printer should cut after executing an FF command, or if it should just feed the
form length.
Determines what should control the page length:
34
1 Default
Auto Cut after FF
0 Min
1 Max
No cut
Cut
Forced cut at blackmark (cuts directly when
a blackmark is detected) This works only if
black mark mode is selected (n36=2).
36
1 Default
Document Mode
DRV
0 Min
2 Max
Fixed Document Mode. Shorter documents
will automatically be extended, while longer
documents will be divided into several pages
of the desired length. Page length will be the
length set by parameters 37 and 38
Variable Document Mode. The length of the
page varies with the contents (printouts
shorter than the value specified by
parameters 37 and 38 will be extended to
that length)
Black Mark Mode. Marks on the paper set
the form length. Minimum one form length
is always fed. If a black mark is found before
that, the printer feeds to the next black mark,
then cuts and ejects. This ensures that no
small paper stripes are cut of and left in the
printer.
Note •
Max page length in Fixed Document Mode is A5-size, which is 148.5 mm.