Zebra Technologies TTP 8000 - Manual (Page 42)

Programming
Text Commands 42
P1003638-003 TTP 8000 Technical Manual 10/19/2009
This command is used to increase the line spacing.
Prints data from the input buffer and feeds the paper to the top of the next page.
In fixed document length (FORM-mode) this command prints data in the input buffer and
feeds the paper to the top of next page.
In variable document length mode the Feed button advances to the minimum page length. If
the printout already is longer than the minimum page length, the Feed button does not feed the
paper at all.
In black-mark mode, the command looks for a black mark, see Z.
If "Auto cut" is set to 1 (see Auto Cut after FF on page 80 ), the Feed button effects form-feed,
cut, and eject.
Shifts the current print position to the next Tab position.
Set tab positions with parameters 15 to 30 on page 79 .
ESC 3 n1
Line Spacing
1B 33 n1 hex
27 51 n1 decimal
Note • Obsolete command, may disappear from future program releases. Use parameter 13
on page 78 instead.
FF
Form Feed
0C hex
12 decimal
Note • Use parameters p37 and p38 to define page length.
HT
Horizontal Tabulation
09 hex
9 decimal