Wegener Communications UNITY 4600 User Manual
Page 52
U
NITY
4600 U
SER
’
S
M
ANUAL
800032-01 Rev. F
44
www.wegner.com
SETLNB {Rf_feed} LO_freq
Rf_feed:
If the RF Switch expansion option is installed, this is one input to that switch (1 through
4). If no RF Switch option is installed, then it is an error to enter data here!
LO_freq:
Either a number or mnemonic. If a number, this value represents the
LNB LO
frequency
in MHz. It can have up to two decimal places and its valid range is from
0
to
14000.00
.
The legal mnemonics are
C
(for Standard C-band, 5150 MHz default),
KU
(for US Ku-
band, 10750 MHz default),
EHKU
(for European Hi Ku-band, 10600 MHz default), or
ELKU
(for European Low Ku-band, 9750 MHz default).
(1) If the current LNB mode selected is
Universal:
This command is legal only when entered without
parameters. In this case, the IRD returns the current calculated setting command sent to the LNB
(either “9.75 GHz” or “10.60 GHz”).
(2) If the current LNB mode selected is
LO:
This command sets the assumed LNB LO frequency to the
value entered in MHz OR the MHz value represented by the mnemonic. If there is an optional RF
switch installed, then the
rf_feed field data must be entered. Entering the command without
parameters returns the current setting.
A Local Control Command (available from the terminal regardless of "Local Control Enable/Disable"
commands from the network).
SETPEDEST xxx
xxx:
E
for enable or D for disable.
Enables or disables the “pedestal” setup, the addition of +7.5 IRE to the luminance level of active NTSC
video, if NTSC is in use. A Local Control Command (available from the terminal regardless of "Local
Control Enable/Disable" commands from the network).
SETPIN value
value:
Decimal representation of PIN key, between
0
and
16777215.
Command sets the PIN scrambling key number.
SETTIMEOUT source time
source:
1 - Not used. (In legacy IRDs, this was Fade timeout.)
2 - Services Recovery Timeout. (In legacy IRDs, this was Installation timeout.)
3 - Network Recovery Timeout. (In legacy IRDs, this was No COMPEL
timeout.
4 - Recovery Iteration Time. (In legacy IRDs, this was Header Seek timeout.)
5 - Local Control Re-enable Timeout. (In legacy IRDs this was Local (Control) Recovery
timeout.)
time:
Time-out value in seconds or
HHHH:MM:SS
format. Minimum value is
1
, and maximum
value
35999999
(9999:59:59
hms) for all others.
Command sets Automated Recovery timeout specified by
source to the value specified by time.
SETUID [id]
id:
Unit ID number between
00
and
99
inclusive.
Command for assigning the unit ID number for gaining "talker" access on a shared serial bus. The factory
default setting for id is '00', which also disables terminal daisy-chain capability. If the parameter is omitted,
then this command returns the current unit ID setting. Command is only applicable to products that feature
serial "daisy-chain".
Table 3.3: Command Directory for U4600 Terminal Commands