Windows Marketplace V.90 User Manual
Page 53
53
ever, may be affected by some ATX options according to country restrictions.
Range:
2-65
Default:
2
Units:
seconds
S7
Connection Completion Time-Out
This register sets the time, in seconds, that the modem must wait before hanging
up because carrier is not detected. The timer is started when the modem finishes
dialing (originate), or goes off-hook (answer). In originate mode, the timer is reset
upon detection of an answer tone if allowed by country restriction. The timer also
specifies the wait for silence time for the @ dial modifier in seconds. S7 is not
associated with the W dial modifier.
Range:
1-255
Default:
50
Units:
seconds
S8
Comma Dial Modifier Time
This register sets the time, in seconds, that the modem must pause when it encoun-
ters a comma (,) in the dial command string.
Range:
0-65
Default:
2
Units:
seconds
S10
Automatic Disconnect Delay
This register sets the length of time, in tenths of a second, that the modem waits
before hanging up after a loss of carrier. This allows for a temporary carrier loss
without causing the local modem to disconnect. The actual interval the modem
waits before disconnecting is the value in register S10.
Range:
1-254
Default:
20
Units:
0.1 seconds
S11
DTMF Dialing Speed
This register determines the dialing speed which is prefixed for each country.