Windows Marketplace V.90 User Manual

Page 33

mode (see AT Escape Sequence, +++).

O1:

This command issues a retrain before returning to on-line data mode.

O3:

This command issues a rate renegotiation before returning to online

data mode.

Result Codes:

n = 0, 1, 3

ERROR

Otherwise

Select Pulse Dialing

This command configures the modem for pulse (non-touch-tone) dialing. Dialed

digits are pulsed until a T command or dial modifier is received. Tone dial is the

default setting.

Result Code Control

Result codes are informational messages sent from the modem and displayed on

your monitor. Basic result codes are OK, CONNECT, RING, NO CARRIER, and

ERROR. The ATQ command allows the user to turn result codes on or off.

Q0:

Enables modem to send result codes to the computer (default).

Q1:

Disables modem from sending result codes to the computer.

Result Codes:

n = 0, 1

ERROR

Otherwise

Select Tone Dialing

This command instructs the modem to send DTMF tones while dialing. Dialed

digits are tone dialed until a P command or dial modifier is received. This is the

default setting.

DCE Response Format

This command controls whether result codes (including call progress and negotia-

tion progress messages) are displayed as words or their numeric equivalents.

V0:

Not supported. Results are always text.

V1:

Displays result codes as text (default).