Windows Marketplace V.90 User Manual
Page 44
44
sending or receiving data.
\N0: Buffer mode. No error control (same as &Q6).
\N1: Direct mode.
\N2: MNP or disconnect mode. The modem attempts to connect in MNP 2-4
error control procedure. If this fails, the modem disconnects. This is also
known as MNP reliable mode.
\N3: V.42, MNP, or buffer (default). The modem attempts to connect in V.42 er-
ror control mode. If this fails, the modem attempts to connect in MNP mode.
If this fails, the modem connects in buffer mode and continues operation.
This is also known as V.42/ MNP auto reliable mode (same as &Q5).
\N4: V.42 or disconnect. The modem attempts to connect in V.42 error control
mode. If this fails, the call will be disconnected.
\N5: V.42 MNP or buffer (same as \N3)
\N7: V.42. MNP or buffer (same as \N3).
Result Codes:
OK n = 0, 1, 2, 3, 4, 5, 7
\Q
Local Flow Control Selection
\Q0: Disable flow control. Same as &K0.
\Q1: XON/XOFF software flow control. Same as &K4.
\Q2: CTS-only flow control. This is not supported, and the response is ERROR.
\Q3: RTS/CTS to DTE (default). Same as &K3.
Result Codes:
OK
n = 0, 1, 3
ERROR
Otherwise
\Rn
Ring indicator signal off after the telephone call is
answered (Compatibility command)
\R0 ring indicator signal is off after the telephone call is answered
Result Codes:
OK
n = 0
ERROR
Otherwise
\Tn
Inactivity Timer
This command specifies the length of time (in minutes) that the modem will wait