Windows Marketplace V.90 User Manual
Page 30
30
L Redials last number. Should be the first character following ATD, ignored
otherwise. The modem displays the dialing string in the following format:
Dialing xxxxxxx where xxxxxxx is the last number dialed.
P Pulse dialing. (e.g. ATDPxxx. Dialing set to pulse as default.)
T Touch-tone dialing (default). (e.g. ATDTxxx. Dialing set to tone as default.)
,
Pause during dialing. Pause for time specified in Register S8 before process-
ing the next character in the dial string.
W Wait for dial tone. Modem waits for a second dial tone before processing the
dial string.
@ Wait for quiet answer. Wait for five seconds of silence after dialing the num-
ber. If silence is not detected, the modem sends a NO ANSWER result code
back to the user.
!
Hook flash. Causes the modem to go on-hook for 0.5 seconds and then re-
turn to off-hook.
;
Return to command mode. Causes the modem to return to command mode
after dialing the number, without disconnecting the call.
^
Disable data calling tone transmission.
S=n Dial a telephone number previously stored using the &Zn=x command (see
the &Zn=x command for further information). The range of n is 0-3.
$
Bong tone detection.
En
Echo Command
This command controls whether or not the characters entered from your computer
keyboard are echoed back to your monitor while the modem is in command mode.
E0:
Disables echo to the computer.
E1:
Enables echo to the computer (default).
Result Codes:
OK
n = 0, 1
ERROR
Otherwise
Fn
On-line Data Character Echo Command
This command determines if the modem will echo data from the DTE. This mo-
dem does not support the F0 version of the command. However, the modem will
accept F1, which may be issued by older communication software, to assure back-
ward compatibility.
F0:
Online data character echo enabled (NOT SUPPORTED, ERROR).
F1:
Online character echo disabled.