Set unit label, Switch application (to different software version), Table 3.13 – Wegener Communications IPUMP 562 User Manual
Page 40: Figure 3.20
Operation
30
800092-01 Rev. A
www.wegener.com
Figure 3.20: iPump 562 OSD Date/Time Setup
Use the
Date/Time Setup
screen to set and display the date and time information.
Table 3.13: Date and Time Information Settings
Set Unit Label
Use following steps to display
Unit Label Setup
screen on the OSD menu:
1. Navigate to the
Unit Setup
screen, see
2. Press the down arrow button to select
Unit Label
.
3. Press
Enter
.
4. When the six-character label is selected, use the up/down and left/right buttons to set
to a desired label. Press
Enter
to save the change. Use the left arrow button to go to
the previous menu level.
Switch Application (to different software version)
Use following steps to display
Application Switch
screen on the OSD menu:
1. Navigate to the
Unit Setup
screen, see
2. Press the down arrow button to select
Switch Application
.
3. View the details as shown in
.
4. Use the
Application Switch
to run a backup version of the software on the unit. Upon
selecting the Backup Software by pressing
Enter
, the system restarts with the
different software which is labeled as current. The previously run software is labeled
Option
Possible values
Current Date
Yyyy/mm/dd
Current Time
Hh:mm:ss
Time zone
All available…
DST
Yes / No