Wegener Communications IPUMP 562 - Manual (Page 24)

Operation
14 800092-01 Rev. A www.wegener.com
Figure 3.2: OSD Main Menu
Push-buttons
Use the arrow buttons and Enter on the front panel to navigate and edit the fields on LCD
and OSD menus. Any of the push buttons activate OSD and LCD. The arrow buttons are
used to navigate through menus and to either change or display items to set desired options
for the IRD. The
Enter button is generally used to select menu items on LCD and OSD
menus. Selectable fields allow you to change the whole parameter from pre-determined
options. Editable fields allow you to change each digit of the parameter. Once a field is
updated, you must select Activate and Exit on the submenu and then press
Enter to update
the value of the field. Before pressing Enter , you may go back to any field and correct it prior
to acceptance. The left arrow button usually steps back a menu.
Table 3.1: Menu Navigation using Push-buttons
LED
Upon power up, the IRD initializes all system components and supplies an operational
status. A steady Green LED indicates that it is locked on a carrier and is capable of
producing output (Audio/Video/Data).
In case of problems, the LED flashes Red for alarm conditions or Amber for warning
conditions. In general, alarms indicate that the unit cannot produce output, while Warnings
Button
Actions
Main Menu Submenu Edit Mode
Enter selects submenu or
drop-down list goes to editable field accepts changes
right arrow no action no action moves cursor to right
left arrow exits OSD goes to previous menu
level moves cursor to left or
abandon changes
up arrow goes to next or
previous menu item goes to next or previous
menu item increases value of selected
item
down arrow goes to next or
previous menu item goes to next or previous
menu item decreases value of selected
item