Wegener Communications IPUMP 562 - Manual (Page 26)

Operation
16 800092-01 Rev. A www.wegener.com
Compel™
System
Control The iPump 562 IRD is most often controlled via the WEGENER Compel Control System .
This system is managed at the uplink site, sending a control stream with the usual audio
and video data streams. The
Compel System addresses units, and commands them to
perform various functions.
Among its functions is the ability to enable or limit aspects of local control. Also, Compel has
the ability to mute the audio and video of an IRD if it is inadvertently tuned to a frequency it
is not authorized to receive.
If an RF Switch option module is installed, Compel controls which of the four RF feeds is
being processed. For more information on this, see the Compel Manual, or contact your
service provider.
There are four levels of control via Compel . These levels are:
No Local Control - Push-buttons disabled
Read Only - No changes permitted
Limited - Changes may be made to Carrier Presets (pre-loaded values) only
Full - Full Local Control
3.2 Normal Functions
The iPump 562 allows several functions for basic operation and optimum performance.
Tune to a carrier
Configure LNB options
Monitor Signal Quality
Set Subtitling
Configure operating options:
Set Decoder options
Setup Audio
Set LAN IP Networking options
Set Terminal options
Set Printer options
Set User Relay
Set Date and Time information
Set Unit Label
Switch Application (to different software version)
Monitor status information:
View Signal Quality
Query Networking History
Display LAN IP Network information
Find Software Version information
Clear Statistics used for diagnosis
Play out play lists of media files
The functions listed above are illustrated below with instructions, OSD screens and other
relevant information.