Set lan-based decode options, Set lan ip networking options, Table 3.9 – Wegener Communications IPUMP 562 User Manual
Page 36: Figure 3.15
Operation
26
800092-01 Rev. A
www.wegener.com
Set LAN-based Decode options
Use following steps to display
Decoder Source
screen on the OSD menu:
1. Navigate to the
Decoder Setup
screen
2. Press the up or down arrow buttons to select
Decoder Source
.
3. Press
Enter
.
4. Press the up or down arrow buttons to select either
LAN-Multicast
or
LAN-Unicast
.
5. Press
Enter
.
6. Select
Activate Settings
.
7. Press
Enter
.
Figure 3.15: iPump 562 OSD Decoder Source
Use the
Decoder Source
screen to set and display the LAN Decode options.
Table 3.9: LAN Decode Options
Set LAN IP Networking options
Use following steps to display
LAN IP Setup
screen on the OSD menu:
1. Navigate to the
Unit Setup
screen, see
2. Press the down arrow button to select
LAN IP Setup
.
3. View the details as shown in
.
Option
Possible values
IP-Address
Multicast or Unicast IP Address
IP-Port Number
The corresponding IP Port number
Audio Routing
Stereo or Left/Right on both
Audio Attenuation
0 through 20
S/PDIF Mode
Passthru, Linear PCM or Off